Optimal Usage Conditions for M30U
Published at: 2026-05-25
Best practices for device performance
Overview
To get the best performance from your M30U, it is important to use the device under the right conditions and follow a consistent routine. M30U combines red light, infrared light, and microcurrent technologies, so proper skin preparation, enough gel, correct mode selection, and regular use are key to achieving better results over time.
Recommended Usage Schedule
We recommend using M30U 5–6 times per week, with one rest day each week.
A suggested weekly routine is:
- Day 1: STAMP
- Day 2: LIFT + SL / EYE
- Day 3: STAMP
- Day 4: LIFT + SL / EYE
- Day 5: STAMP
- Day 6: LIFT + SL / EYE
- Day 7: Rest
Each session usually takes about 6–10 minutes. Please do not exceed 15 minutes per session, excluding the time used for applying gel or skincare products.
Consistency is very important. For best results, follow the routine regularly and give your skin enough time to respond.
Before Each Treatment
Before using M30U, please prepare your skin properly:
- Remove makeup and cleanse your face.
- Make sure your skin is clean before applying gel.
- Remove jewelry, such as earrings, before use.
- Apply enough gel to help the device glide smoothly and improve microcurrent contact.
- Avoid using irritating or photosensitive skincare before treatment.
- Do not use the device together with other beauty devices.
- If you are using it for the first time or have sensitive skin, start from Level 1.
Before first full use, we recommend doing a 24-hour patch test on the inner arm. Use LIFT mode at Level 1 for about 3 minutes. If there is no persistent redness, itching, burning, or discomfort after 24 hours, you may use the device on your face.
During Treatment
Choose the correct mode based on the treatment area and your skin goal.
STAMP Mode
- Treatment area: All facial areas, excluding eye sockets, lips, and inside the mouth.
- Technology: Red light + Infrared.
- Switch reminder: Every 6 seconds.
- How to use: Press the device onto your face and hold for 6 seconds. When you hear the prompt, lift the device and move to the next area.
- Do not stay on the same spot for too long.
LIFT Mode
- Treatment area: Below cheekbones and above the neck.
- Technology: Microcurrent.
- Switch reminder: Every 3 minutes.
- How to use: Apply gel, press the device against your skin, and glide slowly and smoothly.
EYE Mode
- Treatment area: Eye area.
- Technology: Microcurrent.
- Switch reminder: Every 2 minutes.
- How to use: Apply gel and glide gently around the eye area. Avoid direct use on eyelids or inside the eye socket.
SL Mode
- Treatment area: Nasolabial folds and smile lines.
- Technology: Microcurrent.
- Switch reminder: Every 2 minutes.
- How to use: Apply gel and glide along the target area.
After Treatment
After each session:
- Wipe off excess gel.
- Clean the device areas that touched gel or skin.
- Apply gentle hydrating skincare if needed.
- Avoid harsh exfoliation or irritating skincare immediately after use.
- Avoid combining multiple beauty devices in the same routine.
- If your skin feels red, hot, itchy, or uncomfortable, pause use until your skin recovers.
Details
M30U results depend on consistent use, correct mode selection, enough gel, proper skin contact, and skin tolerance. For first-time users, start gently and gradually increase the intensity level only when your skin feels comfortable.
Visible results may take time. Please follow the recommended routine consistently and avoid overuse, as using the device too frequently or for too long may irritate the skin.
Was this article helpful?